Jump to content
  •  
Advertise here

Error code P0201 means...


Recommended Posts

That error refers to a fault found with injector 1

Causes

The causes could be any of the following:

Bad injector. This is usually the cause of this code but doesn't rule out the possibility of one of the other causes

Open in the wiring to the injector

Short in the wiring to the injector

Bad PCM

Possible Solutions

First, using a DVOM check the resistance of the injector. If it isn't within specs, then replace the injector.

Check for voltage at the fuel injector connector. It should have 10 volts or more.

Visually check the connector for damage or broken wires.

Visually check the injector for damage.

If you have access to an injector tester, activate the injector and see if it operates. If the injector operates, then you likely have either an open in the wiring, or a blocked injector. If you do not have access to a tester, swap the injector with another one and see if the code changes. If the code changes, then change the injector.

At the PCM, remove the driver wire from the PCM connector and Ground the wire. (Make sure you have the correct wire. If you're not sure, do not attempt) The injector should activate

Replace the injector

ADAPT Performance - Power Unleashed

SOFTWARE TUNING & PERFORMANCE PARTS

www.adaptperformance.com

Link to comment
Share on other sites

  • 5 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of use