peter24

Always take care of the blind spot when you know they is a heavy vehicle near to your car. Also, never try to over speed or take over the heavy vehicle. Do not drive very close to the heavy vehicle to about any accident.

Ok. And can yu explain these positions.

Always use the fuel which is matching the viscosity that is recommended for your car.

Can someone describe the positions of the ignition switch.

The front end clunks in mazda2, 2010 model is gone bad. How to fix it?

How to quickly check the charging system of a car?

Well in that case, you need to own a smart phone. It can be any brand. Just download RTA app in that which acts as a free navigator in complete Dubai. You don't need a WiFi or data for this application. It works on satellite. And it navigates when you are in the car, or walking or even using a public transport. I suppose that can solve your issue.

I tried to find pocket navigation too. But it wasn't available anywhere.

Hey guys. How can I check my brake pads if they are working fine. I am not really good with cars. Do please let me know if I can actually perform such a task.

Hey people. The alternator in my Toyota Camry is not working. I need to change it. Can I do that on my own?

What are synthetic motor oils? And is it better than the ordinary oils?

My be the oil level in your car is low or may be the fluid is contaminated.

i like Infiniti better than Lexus as it is more reliable and comfortable.

Actually it completely depends on the type of dent. As you are mentioning that the dent is not that big, then I would suggest you to perform DIY. It’s easy and quick. You will need: hand gloves, hair dryer and dry ice or compressed air spray. Do as per the following steps: Take an aluminum foil and cover the dented area with that. Now, take a hair dryer. Don’t pressurize the area with too much hot air, so keep the hair dryer on the medium level and start drying the dented area (covered with foil). Do this for at least 10 min. when the car paint slowly starts melting. When the paint starts melting, it’s time for you to give the dented surface something cold. Put the gloves on and either you can use dry ice or compressed air spray. If you are using dry ice, spread the ice on the dented surface softly. If you are using the compressed air spray, spray it in the upside down motion. Continue doing this for 5 to 10 min., when you will start realizing that the dent is coming out. Finally you can remove the aluminum foil, and check the difference on your own. This method is really helpful when you are performing it on a small dent. If the dent is big, more pressure it required which is not possible by DIY and that’s why people give it to the workshop. This method is really common. The main criterion is to pressurize the surface by hot air and then cool air, which automatically force the dent to pop out. But don’t forget to wear gloves in your hands when you do this, because when using dry ice, it may damage the hand. To avoid that, gloves is the best alternative.