Jump to content
  •  
Advertise here

Ford Edge Transmission failure


Arran

Recommended Posts

  • 2 months later...

Why would you spend extra money changing 3 sensors when only one is possibly faulty? That's a very main dealerish attitude towards repair. The correct procedure would be to scan the fault code memory and see what it says. If a sensor has an intermittent fault, there will be a code logged towards it. If no codes are logged, the vehicle should be driven whilst plugged into the diagnostic tool and live data monitored and recorded so you can see exactly what's going on when the fault occurs. Even this doesn't mean a sensor is faulty. The wiring must be thoroughly inspected along the complete length from the transmission to the ECU. I have seen similar faults occur where 'mechanics' change and change various sensors but the fault still exists when the real issue was damaged sheathing causing the wires to the sensor to short circuit and send the vehicle into limp mode which was reset by turning the vehicle on and off again.

  • Like (+1) 2
Link to comment
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of use