shamal

It is not a good idea as you would have to completely disassemble it, it wont matter if it is the drive end or brush end bearing.

The task is very simple. You can change in about 15 minutes, without removing the headlights. passenger side was the easiest, just pop out the airbox. Driver side has the washer fluid in the way but I removed one bolt I think and tilted the fluid box back... How to remove the headlights too. quick summary for those removing the headlight assembly. There are three 10mm Bolts that hold the assembly. The two that are on top are easy. The third is located underneath which is located behind the wheelwell. BUT you MUST remove all the the grille snaps. Also, you must remove two 10mm bolts behind the wheelwell to remove the headlight housing. The reason for all the other bolt/snaps removal is to make sure you don't scratch the bumper or grille when removing it.

Visual look. If it looks clog and too dirty and turned black and cant air clean any further, better change

Its a bend or broken axle. Very difficult to break unless you have an accident or jumped on footpath with high speed.

http://www.cadillacforums.com/forums/ca ... valve.html

First doubt is fuel filter, second doubt is fuel pump. No other things to doubt in such cases.

i have a 2004 Escalade which is having a start up issues that is when I start my car it may or may not start. so when i start the ignition i have to wait atleast 5 min. the time has started increasing day by day. it is not only the cold start but whenever i start the car in the entire day. what could be the cause