Jump to content
  •  

vinodf

Members
  • Posts

    5
  • Joined

  • Last visited

  • Carnity Points

    0 [ Donate ]

vinodf's Achievements

New Joiner

New Joiner (1/14)

0

Reputation

  1. Ankesh, If your spark plug, HT lead and coil is good then I think your idle need to be adjusted by adjuster or check the Idle control Valve with voltmeter if its gone bad.
  2. 3008 is a beautiful and safe SUV fit for the purpose that you are looking for. If you going for brand new then you need not to really worry about maintenance cost as with every new model it comes with free service and maintenance contract if I am not wrong. Even if i am wrong, new Peugeot is very good for 3-5 years easily without throwing hefty maint bills so you are again covered. Yes if you compare that size of vehicle with 208 or 308 then yes it cost slightly more maintenance, but try comparing with other SUV to be fair in same league as VW, Nissan, Toyota etc.
  3. Tire date is imprinted on side wall near the bead in (WEEK/YEAR) format which means if it reads 2212 then tire is manufactured in 22nd week of 2012. Juju: You can go to radial tires (04 2690106) in deira, they have nice wheel balancing and alignment setup. You can also get same job done in few emarat petrol stations as well.
  4. Looks like too many question here and too little answer. As everyone want to ask and no one want to answer. masmic: Using repaired puncture tire is absoultely ok as far as it has remaining tread life and less than 3 year old, and puncture is repaired perfectly. dewnani and shine: Its not about the cost of tire, but why waste something that can be 100% safely used. Its called wastage of money. juju: Brand new tires would cost in range of 300 - 800 depending on your car tire size and brand you pick. Kamrul: Best tire in my knowledge are Michelin, but they are fucking expensive so second close bet is Bridgestone or Good year they both are equally good and reliable. Bond207: Upgrading to one size means radius = NO, stick to your size. If upgrading to one size in profile or width = may be depending on how close you get with rubbing on full U-Turns.
×
×
  • Create New...

Important Information

Terms of use