Jump to content

riaaz

Members
  • Posts

    9
  • Joined

  • Last visited

  • Carnity Points

    0 [ Donate ]

Posts posted by riaaz

  1. FIRST REMOVE THE STUD

    Raise the vehicle and safely support it with jack stands, then remove the wheel.

    Remove the brake drum and brake shoes.

    Using a large C-clamp and socket, press the stud from the axle flange.

    Cover the serrated part of the stud with liquid soap and place it into the hole.

    FOR INSTALLATION:

    PLACE about 4 flat washers over the stud and thread the lug nut. Hold the flange while tightening the lug nut.

    the stud should be drawn into position, then remove the lug nut and washers.

    Install the wheel, then remove the jack stands and carefully lower the vehicle.

    Tighten the lug nuts to the proper torque take a friends help

  2. Check the sprak plug and spark coming in all plugs are good and strong or not before jumping to cylinders.

    Then you can suspect the injector and then cylinder valves in end. In this case put injector cleaner in quarter tank and drive at 140 for 1 hr, it will be fine hopefully (75% chances).

  3. Try scratch out rubbing polish with your elbow grease for 3-4 times and if its slight dim, then change the bulb to normal 55W original from bosch or company.

    Dont buy aftermarket light it will blind incoming traffic and also might get you fine from Dubai police if its blinding due to its wrong aligned.

×
×
  • Create New...

Important Information

Terms of use