mohitmust

I have Kia soul. My car was completely fine unless the headlights of my car started blinking. It wasn't stable at all. But i don't know why is it so!

I can see oil pressure light on the dash of my car. What does that mean? I have Honda accord from 4 years now, but never had such an issue

Off course its very risky. Basically the Drive on car ramps are never straight and always sliding. So even if you fix your car wheel on the ramp, there is no support from the other side to keep the wheel still on the ramp. So lets say if you are performing any task under the car and suddenly the tire loose control from the ramp, it may slide down and anything can happen to the person performing task under the car.

What does it mean by Key OFF current drain in a car battery?

Well, what do I say? I am just fed up of my car now. Yesterday my Tiida couldn’t start. There is no crank and no start. I am not a mechanical person, but is there anyone who can help me knowing what’s wrong in the car?

Hey everyone, please help me. Can anyone tell me how to correct the steering pulls in Kia picanto, 2007 model?

What is a Transaxle in a car?

There is always dust in the disc brake of my car. Is there any possibility to prevent that dust?

Yes you can do it, but make sure you have done the wheel alignment before or atleast try to take help from an expert. You can do as follows: Firstly, you need to keep the front wheels of your car on jack stands. After doing that, activate you power steering by turning the car key to the ignition, but DO NOT switch on the car. Before starting, make sure that the steering wheel is at the center. To check the alignment you can use a straight broom. You need to adjust the broom in such a way that it’s between the fender edges of the wheel. Hold the broom properly and it will help you knowing the direction of the wheel pointing to. Either the wheels will be pointing inward or outward. Inward means that it is pointing towards the center of the car. Id f that’s the case, tightening the outer tie rod will help in aligning the wheel to the normal position. If it’s outward positioned, you need to loosen up the outer tie rod. Then move your wheel to the left, right and center position and check if it is aligned properly. Repeat the same procedure to the other frn end wheel. Not forget to tighten the tie rod before you finish. Take your car for the drive and check if the alignment is proper or not.

Somewhere it’s true actually. I owned 3 BMWs, and trust me the noise from the engine was the common problem in all. I don’t say the choice is bad, but the manufacturing is not that great, that’s why, noise from all the three cars. It’s a good choice, but maintenance can really make you nuts sometimes.