sharmaa

You have to buy the GCC maps from dealer mate, thats the only expensive option here. And you also might need to update the software for installing GCC maps, that dealer can do that for you with little extra service charge.

where good quality of rims i have seen on BMW road in Sharjah. these shops have good designs too and reasonable rates too.

For road comfort and stable ride quality OEM is always advisable, but if you go offroad and want stiffer ride quality then seek Old Man / Dobinsons / Bilstein shocks with stock springs or King springs.

Usual suspect or rather culprit for such overheating is AC fan. AC fan must be bad and that's why while on idle when no wind comes from front and that's why car overheat. Check the AC electric fan in front of radiator should work when you switch on AC, if its not working then get the fan changed as its not repairable item.

Looks like your 4wheel is engaged and that's why it throws the light of 4W after 82kmph as you should never drive 4W cars with 4W on normal tarmac road more than 80kmph.

Switch of 4W and you will be fine.

First remove the engine cover. Then remove the sparkplugs electroinc igniter on top of spark plugs. Igniter is fixed with 10mm bolt and then pull out the spark plug wires and the spark plugs are inside the hole... then remove the spark plug with normal spark plug socket. This setup is also known as coil on plug setup.

The Hot - Cold blender must be stuck in Hot position.

check it

It looks like Spark Plug issue or a starter or a fuel pressure problem

Here are the following steps to bleed the transmission

1. Drain the fluid from the pan. Once you've replaced the filter, the pan gasket, and reinstalled the pan

2. Fill the transmission to its level with transmission fluid.

3. Disconnect the line in which transmission fluid flows from the transmission cooler back to the transmission. Once the line has been disconnected attach a clear piece of tubing to the transmission cooler, the same size as the transmission line, using the transmission line clamp to secure it.

4. Place the unattached end of the clear tube in a plastic and a container under the car.

good luck

Yes get the rust proofing done. Its a thick black substace that get applied (sprayed usually) under the car and it protect car chasis and other metal parts from getting rusted. Ask any good body workshop guys and they will do it in less than 100 aed.

Fuel tank cleaning will be done at mechanic, not at eppco and unfortunately it can be done quickly. It will take at least 2 hrs. Seek a good mechanic and he can open the tank from drain valve and clean it.

Search the shj scrap behind macro supermarket after BM road maza signal. There are plenty of Infiniti scrapyard having cosmetic parts from japanese import.

It could be a half blown fuse, check the melted fuse if this is troubling. If not you have to open the steering wheel and check and clean the contact there for horn.

You have to remove the front wheel to reach the spring and strut. Better get with proper mechanic as you need more than one Jack at a time. One to support vehicle from side you are working and second to lift the strut part to take it out.

If you using the OEM spec tires that comes with your car (refer to manual) then use the OEM specified tire pressure. If little plus minus size then also stick to OEM specification on tire pressure. If huge variance then refer to tire spec and make sure you inflate the under MAX pressure written on tire.

Usually OEM is 30 PSI - 35 PSI in all 4 tires.

where is the crank sensor in a qx4 2006 infiniti

please answer