Looper

The side that goes into the tire is universal. One can either thred it in or clip for quick access. For you probably only the screw type nozzle will work. the one at the back of the inflator that goes into the pipe that comes from the compressor needs to be checked as they tend to be different. On my ARB it takes 1/4 inch NPT is size. I had previously bought 1/4 one from ACE that looked pretty much like ARB and was marked as 1/4 inch but it did not fit on the ARB.

The US Inlet male connector is used by ARB. If it does not work on yours - may be the japanese type could work. In the picture below it has the clip on Air Cuck installed on the Air Gun, But as i mentioned earlier I used the Threaded type inflatable nozzel shown below and added an extra nozzle on top of it.

@Jessica Lambert, I used following: 1. Busgrabger 3-in-1 Tire Gauge & Deflator: that i had bought at Ace Hardware you might get it on Amazon as well. 2. A generic Inflation gun off Amazon. It came with two types of air chuck one to screw and another clip on. I have used the screw type on my inflation gun in and on top of that I added clip on air chucks (i bought separately) so i have both available for use. It also comes with two types of connections 1 for ARB and other one i guess can be used on Meanmother. We could have tested the other connector on your compressor, while I made a note of it at the beginning of the drive, I forgot at the end of the drive.

This is Part 1 of 2 part video series.

In fact, these tend to break at the place they have contact with the hook from the base as well. As far as sand is concerned - even the spring ones have issues. A Can of WD40 applied once in a while after the last drive of the week keeps them clean from inside.

Another version of it.